The original part is an isolated, switched-mode converter; high efficiency. The LM317 is a non-isolated, linear regulator, and not suitable for 48V input. (A linear regulator with 48V input & 15V output to a 2W load would be dissipating almost 4W of heat; it would need quite a large heatsink adding, making it overall far larger than the original device, as well as wasting a lot of energy ...
I have put back together the entire gimbal already, and I would much rather superglue a plastic piece to the motor than fully disassembling the gimbal again and replacing the motor entirely. I am also looking for replacement Philips 1 screws for the gimbal internals. does anyone have the specs on the screws?
Repair Service: Replacing the LR arm axis was honestly a relatively easy repair. After replacing the arm, and powering up the gimbal does its vertical and horizontal tests, but the roll motor "snaps" to ~-45* offset and doesn't move. The roll motor "buzzes" lightly and stays engaged, providing resistance to the touch.
Aren't you replacing both the camera and gimbal, I've always seen them sold together as one component ? This would seem easier then just replacing the camera by itself.
You can try replacing it. I'd use a 2A standard diode. The leads and body look too fat for a simple 1N4001 to 1N4007 range. Also, are you sure it's the problem? Is this the switch by the driver's left knee? To toggle the dome light from always-on to off to on-when-door is open? Or the door switch.
I have a Definitive Technology compact subwoofer that went belly-up and started buzzing constantly instead of producing any sound. After research, I decide to try replacing the primary 6800uf 80v capacitors . After replacing the caps, the behavior has changed, but not really for the better...
I was swapping motherboards between two of my Mini 3 Pros, and noticed that one of the 4x arm antenna connectors was damaged and would not reattach to the new motherboard. I cut it off thinking I could re-solder an undamaged connector on it, but the wire was far too intricate and delicate to be...
Hi everyone, My DJI RC with the integrated screen, bought with my Mini Pro 3 two years ago, is now showing its age. Even when charged to 100%, it drops to 80% after a few hours in storage and looses 15-20% per flight, making longer days difficult. I tried to get a battery replacement quote...
